- Leather Strap 2.8
- Strap Gallery
- Leather Strap 2mm
- Leather Thonging
- Veg-Tan Strap
- Trigger Hooks / Clips
- Leather Dyes
- D rings O rings
- Buckles
- Rivets
- Square Braid
- 3 Strand Mystery Braid
- Lacemaker Video
- Press Studs
- Polypropylene Webb
- DIY DVDs
- Leathergoods Fittings
- Thread/Sewing
- Lacemaker Tool
- Rocking Horse Stirrups
- Split Rings / Key Rings
- Upholstery
- Craft Fibres
- Resin Buttons
- Wood Buttons
- Jumprings
- Cord End Crimps
- Earring Findings
- Brooch Back / Kilt Pins
- Pendant Charms
- Toggle Clasps
- Lobster Clasps
- Head & Eye Pins
- Craft Tools
- Craft Eyes
- Tiara Craft Base Bands
- Hook & Loop Tape
- Knitting / Crochet
- Gift Bags
- Beads
- Pocket Watch Pictures
- Pocket Watches
- Display Cards
- Chain
- Links
- Contact
How to use a thong cutter lacemaker tool
Instructions
FIG 1. Start by cutting approximately 11/2 inch (40mm) diameter hole in the centre of leather piece.
Select the proper width slot for thickness of leather being used.
For easier starting of lacemaker into cut, hold leather between first two fingers, thumb and third finger. Push cutter against leather and push farward until a small bit of lace appears beyond the back of the cutter.
FIG 2. Grasp small lace projection and pull allowing the leather to rotate.
Continue until a leather lace of desired length is obtained or outer edge of leather piece is reached.
To remove a dull cutter or place in a different groove for a different width of lace, push top spring up and lower spring down. Lift out cutter and discard or change groove, then replace springs to original position.
How to use an Aussie Strander Lace Cutter
